Oil, Water & Stain Repellant Penetrating Concrete Sealer
SharkSeal™ is a water and oil repellant penetrating concrete sealer with color enhancing properties based on a blend of complex resins including nano-enhanced fluoropolymers.
It penetrates deep into porous surfaces such as interior or exterior concrete, stone and pavers, yet is compatible as an enhancing sealer over NewLook color stains.
Easily clean surfaces with SharkSeal™ as it repels dirt, dust and resists stains from most common spills including dirty auto fluids, beverages and many other fluids. SharkSeal has low VOC’s and will not blush or yellow.
Prolongs the life of concrete affected by winter freeze-thaw cycle and salt intrusion. SharkSeal™ is breathable, dries quickly, with strong abrasion and chemical resistance, and good hot/wet tire pickup resistance. It also enhances the color of the substrate when it is applied in two wet-on-wet coats.
Features & Benefits
- Indoor & Outdoor Use
- Low VOC
- Repels water
- Repels oil
- Repels dirt
- Reduces freeze/thaw damage
- Use on concrete, pavers & stone
- Water, oil & stain repellant
- Works over water-based or acid stains
- Non-yellowing or blushing
- Good hot/wet tire pickup resistance
- Breathable, dries quickly, with strong abrasion and chemical resistance
How it Works
SharkSeal™ is a water and oil repellent penetrating sealer with color enhancing properties. It is designed to penetrate deeply into porous surfaces such as interior or exterior concrete, stone and pavers, yet is compatible as an enhancing sealer over NewLook color stains.
Where to use SharkSeal™
SharkSeal™ works great for surfaces that require a higher-end, yet cost-effective finish that holds up very well to traffic such as in industrial floors, driveways, garage floors, retail and restaurant floors, etc. Performs very well over decorative concrete including stained and stamped concrete, overlays, natural/manufactured porous stone, pavers and exposed aggregate.
Packaging & Application
SharkSeal™ Penetrating Concrete Sealer is available in the following sizes:
Apply heavy to the point of rejection with two wet-on-wet coats achieving approximately 200 – 300 square feet (18 – 27 square meters) using a pump or airless sprayer, or with a brush, low-nap roller or microfiber pad on tighter surfaces.